flat-roof-repair.com is for sale — buy the domain, or the domain plus this complete website →

Glossary

Flat roofing glossary

The words roofers use, explained in plain English.

Flat roofing glossary
Base flashing
Membrane turned up a wall or curb to seal the roof-to-wall joint.
Built-up roof (BUR)
Multiple plies of felt and bitumen, usually surfaced with gravel.
Cap sheet
The top, often granule-surfaced, ply of a modified bitumen or BUR roof.
Coping
Metal or stone cap on top of a parapet wall.
Counter-flashing
Metal that overlaps base flashing to shed water away from its top edge.
Cover board
Thin, tough board over insulation that protects it and gives the membrane a solid base.
Cricket / saddle
A small built-up area that diverts water around a curb or toward a drain.
Deck
The structural surface (wood, steel or concrete) the roof system sits on.
EPDM
Ethylene propylene diene monomer: a synthetic rubber single-ply membrane.
Fully adhered
Membrane glued to the substrate across its whole area.
Mechanically attached
Membrane fastened with plates and screws in the seams.
Ballasted
Membrane held down by stone or pavers.
Modified bitumen
Asphalt modified with SBS or APP polymers, reinforced and installed in rolls.
NDL warranty
"No dollar limit" manufacturer system warranty.
Parapet
A low wall extending above the roof at its edge.
Pitch pan / pocket
A sealant-filled collar around an irregular penetration.
Polyiso
Polyisocyanurate rigid foam insulation board commonly used under membranes.
Ponding
Water remaining on a roof about 48 hours after rain.
PVC
Polyvinyl chloride single-ply membrane, heat-welded, good chemical resistance.
Recover
Installing a new roof over an existing one.
Scupper
An opening through a parapet or edge that lets water drain off the roof.
Seam probe
A hand tool used to check welded seams for gaps.
Single-ply
A roof membrane installed as one layer: TPO, EPDM, PVC.
SPF
Spray polyurethane foam roofing, protected with a coating.
Tapered insulation
Insulation boards manufactured with slope to direct water to drains.
Termination bar
Metal bar that fastens the top edge of flashing to a wall.
TPO
Thermoplastic polyolefin single-ply membrane, heat-welded, usually white.
Walkway pad
Protective pads that create safe paths and protect the membrane.

Stop the leak. Then fix the roof properly.

Get a clear diagnosis, a written scope and a fair price range before anyone touches your membrane.

Cost estimatorRequest an assessment